Tasmota/lib/IRremoteESP8266-2.6.0/examples/IRrecvDemo/IRrecvDemo.ino

53 lines
1.6 KiB
C++

/*
* IRremoteESP8266: IRrecvDemo - demonstrates receiving IR codes with IRrecv
* This is very simple teaching code to show you how to use the library.
* If you are trying to decode your Infra-Red remote(s) for later replay,
* use the IRrecvDumpV2.ino example code instead of this.
* An IR detector/demodulator must be connected to the input kRecvPin.
* Copyright 2009 Ken Shirriff, http://arcfn.com
* Example circuit diagram:
* https://github.com/markszabo/IRremoteESP8266/wiki#ir-receiving
* Changes:
* Version 0.2 June, 2017
* Changed GPIO pin to the same as other examples.
* Used our own method for printing a uint64_t.
* Changed the baud rate to 115200.
* Version 0.1 Sept, 2015
* Based on Ken Shirriff's IrsendDemo Version 0.1 July, 2009
*/
#ifndef UNIT_TEST
#include <Arduino.h>
#endif
#include <IRremoteESP8266.h>
#include <IRrecv.h>
#include <IRutils.h>
// An IR detector/demodulator is connected to GPIO pin 14(D5 on a NodeMCU
// board).
const uint16_t kRecvPin = 14;
IRrecv irrecv(kRecvPin);
decode_results results;
void setup() {
Serial.begin(115200);
irrecv.enableIRIn(); // Start the receiver
while (!Serial) // Wait for the serial connection to be establised.
delay(50);
Serial.println();
Serial.print("IRrecvDemo is now running and waiting for IR message on Pin ");
Serial.println(kRecvPin);
}
void loop() {
if (irrecv.decode(&results)) {
// print() & println() can't handle printing long longs. (uint64_t)
serialPrintUint64(results.value, HEX);
Serial.println("");
irrecv.resume(); // Receive the next value
}
delay(100);
}