diff --git a/Zigbee.md b/Zigbee.md
index 65ff82ae..f775ba63 100644
--- a/Zigbee.md
+++ b/Zigbee.md
@@ -64,13 +64,13 @@ Once the firmware upload completes, retain the serial interface connections (3.3
 ### B. Connect the CC2530 and the ESP82xx
 The DL-20 Zigbee module has a 5-pin 1.27mm pitch unpopulated header with 0.6mm througholes. For flashing any of the Zigbee modules, you need the following connections:  
 
-ESP<BR>Pin|D1 Mini<BR>NodeMCU|CC2530<BR>Pin|DL-20 J2<BR>Pin Location
+ESP<BR>Pin|D1 Mini<BR>NodeMCU|CC2530<BR>Pin|[DL-20 J2<BR>Pin Location](https://user-images.githubusercontent.com/34340210/67676080-29301a00-f957-11e9-8799-c819241e0b4c.png "CC2530 DL-20 Pin-outs")
 :--:|:--:|:--:|:--:
-GPIO12|D6|CC_DD<BR>(A.K.A. P2_1 or Debug Data)|1
-GPIO4|D2|CC_DC<BR>(A.K.A. P2_2 or Debug Clock)|2
+GPIO12|D6|CC_DD<BR>(A.K.A. P2_1 or Debug Data)|5
+GPIO4|D2|CC_DC<BR>(A.K.A. P2_2 or Debug Clock)|4
 Vcc|3.3v|Vcc|3
-GPIO5|D1|CC_RST|4
-GND|GND|GND|5
+GPIO5|D1|CC_RST|2
+GND|GND|GND|1
 
 **DL-20 Flashing Jumpers**  
 Insert alternating male Dupont jumpers; one jumper on one side, the next one on other side. This  allows the pins to provide the friction themselves to maintain contact and remain firmly in place. You only need DD, DC, and RST (a fourth jumper is shown which is used to keep the RST jumper in place). Vcc and GND are available on the main serial interface pins.