diff --git a/Zigbee.md b/Zigbee.md
index 860a7d22..83223af8 100644
--- a/Zigbee.md
+++ b/Zigbee.md
@@ -45,9 +45,9 @@ Z2T requires a TI CC2530 based module flashed with [Z-Stack-firmware](https://gi
 ### A. Flash CCLib on an ESP82xx Device
 Flashing the CC2530 normally requires a [CC_DEBUGGER](https://www.aliexpress.com/item/32869263224.html). Using an ESP82xx device like a [Wemos D1 Mini](https://www.aliexpress.com/item/32681374223.html) is a lower cost alternative.  
 
-Follow the usual ESP82xx [flashing process](Flashing) - you are just using [`CCLib_proxy.ino.bin`](https://github.com/s-hadinger/CCLib/blob/master/Bin/CCLib_proxy.ino.bin) instead of Tasmota.
+If you are using a Wemos D1 Mini or NodeMCU, just plug the microUSB port. Vcc (3.3V), GND, Tx (GPIO1), and Rx (GPIO3) are connected via the microUSB port. Be sure that you are using a USB **_data_** cable.  
 
-For Wemos D1 Mini just plug the USB port. For non USB ESP devices, connect as follows: 
+For ESP devices that do not have a microUSB connector, make the following connections:  
 
 <BR>ESP<BR>Device|Serial<BR>Programming<BR>Adapter
 :--:|:--:
@@ -57,7 +57,7 @@ GPIO0|GND
 GPIO1|Rx
 GPIO3|Tx
 
-Vcc (3.3V), GND, Tx (GPIO1), and Rx (GPIO3) are connected via the USB on a Wemos D1 Mini.
+Follow the usual ESP82xx [flashing process](Flashing) - you are just using [`CCLib_proxy.ino.bin`](https://github.com/s-hadinger/CCLib/blob/master/Bin/CCLib_proxy.ino.bin) instead of Tasmota.
 
 Once the firmware upload completes, retain the serial interface connections (3.3V, GND, Tx, Rx). These will be used later for flashing the CC2530.