diff --git a/MagicHome-LED-strip-controller.md b/MagicHome-LED-strip-controller.md
index 3fdd004f..de6214b8 100644
--- a/MagicHome-LED-strip-controller.md
+++ b/MagicHome-LED-strip-controller.md
@@ -24,7 +24,7 @@ Board has RX, TX, GND and GPIO00 pads exposed on the bottom side of the PCB. You
 
 You need to power the board while keeping it connected to the programmer.
 
-With all Sonoff boards that works with AC, this is a big no-no that will fry your programmer, your Sonoff and might even get you killed.
+With all Sonoff boards that work with AC, this is a big no-no that will fry your programmer, your Sonoff and might even get you killed.
 In this case, you'd be dealing with 12V, so the only thing that matters is to connect the GND of your programmer to GND of the board before you supply the 12V. Not doing so might fry your board and/or programmer, but would definitely not hurt you. 
 
 Steps used: