From 0d9c8a496d2683583a9622e3f486dbf671245fff Mon Sep 17 00:00:00 2001 From: Oli Norwell Date: Thu, 13 Sep 2018 14:44:22 +0200 Subject: [PATCH] works changed to work (boards is plural) --- MagicHome-LED-strip-controller.md | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/MagicHome-LED-strip-controller.md b/MagicHome-LED-strip-controller.md index 3fdd004f..de6214b8 100644 --- a/MagicHome-LED-strip-controller.md +++ b/MagicHome-LED-strip-controller.md @@ -24,7 +24,7 @@ Board has RX, TX, GND and GPIO00 pads exposed on the bottom side of the PCB. You You need to power the board while keeping it connected to the programmer. -With all Sonoff boards that works with AC, this is a big no-no that will fry your programmer, your Sonoff and might even get you killed. +With all Sonoff boards that work with AC, this is a big no-no that will fry your programmer, your Sonoff and might even get you killed. In this case, you'd be dealing with 12V, so the only thing that matters is to connect the GND of your programmer to GND of the board before you supply the 12V. Not doing so might fry your board and/or programmer, but would definitely not hurt you. Steps used: