From 1325cf0a5dbec7b672352a4c571e9c1b696225f8 Mon Sep 17 00:00:00 2001
From: Michael Ingraham <34340210+meingraham@users.noreply.github.com>
Date: Sat, 13 Jul 2019 14:22:13 -0400
Subject: [PATCH] Updated ERC309 Kinetic Switch (markdown)
---
ERC309-Kinetic-Switch.md | 11 ++++++-----
1 file changed, 6 insertions(+), 5 deletions(-)
diff --git a/ERC309-Kinetic-Switch.md b/ERC309-Kinetic-Switch.md
index 1097885c..426fc51b 100644
--- a/ERC309-Kinetic-Switch.md
+++ b/ERC309-Kinetic-Switch.md
@@ -8,17 +8,18 @@ Configure as a `Tuya Dimmer (54)` (support as a BASE module was introduced in 6.
- GPIO13 - Tuya Rx (108)
- GPIO15 - Tuya Tx (107)
+
-Template: {"NAME":"Kinetic Switch","GPIO":[255,255,255,255,255,255,0,0,255,108,255,107,255],"FLAG":0,"BASE":54}
-
-[Module](https://user-images.githubusercontent.com/34905120/47967431-4a537880-e02b-11e8-955b-ee9843bd222d.jpg)
+- Template: {"NAME":"Kinetic Switch","GPIO":[255,255,255,255,255,255,0,0,255,108,255,107,255],"FLAG":0,"BASE":54}
+- [Module](https://user-images.githubusercontent.com/34905120/47967431-4a537880-e02b-11e8-955b-ee9843bd222d.jpg)
+
[`SetOption34`](Commands#setoption34) - Set the Tuya Dimmer device ID
-[`Setoption65 1`](Commands#setoption65) - Enable slider control
-
_If power on/off works, but dimming doesn't, you probably haven't set the correct ID_
+[`Setoption65 1`](Commands#setoption65) - Enable slider control
+
#### Flashing
This device uses a Tuya TYWE3S Wi-Fi PCB module. An easy soldering method is to take several Dupont style jumper wires, cut one end off, and apply a bit of solder to each stripped end. This will keep the wire flexible and prevent any circuit board pads from ripping off. Apply a bit of solder to each pad necessary to flash (double check your pin-outs). Once the wire and pad have solder simply put the two together and apply a bit of heat and they will join together.