diff --git a/Configuration-Procedure-for-New-Devices.md b/Configuration-Procedure-for-New-Devices.md
index 49c70f9e..2920a286 100644
--- a/Configuration-Procedure-for-New-Devices.md
+++ b/Configuration-Procedure-for-New-Devices.md
@@ -16,7 +16,7 @@ If your device is similar to the existing module it is best to use that as a sta
 
    _a._ Save the configuration. Once the device reboots, use the web GUI Console to run the<br>`Status 8` (sensors) command. This will display the current state of each GPIO.
 
-   _b._ Then, while pressing each button, display `Status 8` again. Whichever GPIO changes state from what was shown in step _1a_ is the GPIO tied to the button.
+   _b._ Then, while pressing each button, display `Status 8` again. Whichever GPIO changes state from what was shown in step _2a_ is the GPIO tied to the button.
 
       - If none of the GPIO change state, then configure the "dedicated" GPIO and retry.