diff --git a/Sensor-Configuration.md b/Sensor-Configuration.md
index b060fb9d..76b86d4f 100644
--- a/Sensor-Configuration.md
+++ b/Sensor-Configuration.md
@@ -1,13 +1,13 @@
Pre:
[How To Connect a Sensor](https://github.com/arendst/Sonoff-Tasmota/wiki/Expanding-Sonoffs)
-The software allows for dynamically configuration of sensors and devices to selected GPIO pins. Depending on the type of (Sonoff) Module certain GPIO pins are easily accessable.
+The software allows for dynamically configuration of sensors and devices to selected GPIO pins. Depending on the type of (Sonoff) Module certain GPIO pins are easily accessible.
Sensor configuration is possible by either the web pages OR using the commands ``modules``, ``module``, ``gpios`` and ``gpio``.
The software supports:
- [single wire sensors](#single-wire-sensor)
-- [dual wire or I2C sensors](#i2c-sensor)
+- [dual wire or I2C sensors](#i2c-sensor)
- [single wire devices](#device)
Only one sensor per group is allowed.
@@ -40,8 +40,8 @@ For some sensors to show up a power cycle of Sonoff is needed to reset the devic
-## I2C sensor
-The following I2C sensors are supported using ``I2C SCL (5)`` and ``I2C SDA (6)`` in group 3:
+## I2C sensor
+The following I2C sensors are supported using ``I2C SCL (5)`` and ``I2C SDA (6)`` in group 3:
@@ -59,16 +59,16 @@ The following I2C sensors are supported using ``I2C SCL (5)`` and ``I2C SDA (6)`
- SHT11 Temperature and Humidity in group 3c
- SHT15 Temperature and Humidity in group 3c
-You can add I2C sensors using the following (MQTT) commands:
+You can add I2C sensors using the following (MQTT) commands:
1. ``modules`` - show supported modules
2. ``module 1`` - select desired module functionality for a Sonoff Basic (Wait for the restart)
-3. ``gpios`` - show supported sensor types. We need two pins: I2C SCL (5) and I2C SDA (6)
+3. ``gpios`` - show supported sensor types. We need two pins: I2C SCL (5) and I2C SDA (6)
4. ``gpio`` - show current defined sensors on supported GPIO pins
-5. ``gpio14 5`` - select I2C SCL (Wait for the restart)
-6. ``gpio4 6`` - select I2C SDA (Wait for the restart)
+5. ``gpio14 5`` - select I2C SCL (Wait for the restart)
+6. ``gpio4 6`` - select I2C SDA (Wait for the restart)
-The software will autodetect the connected I2C devices. For some sensors to show up a power cycle of Sonoff is needed to reset the devices just configured.
+The software will autodetect the connected I2C devices. For some sensors to show up a power cycle of Sonoff is needed to reset the devices just configured.
## Device
The following additional device(s) are supported: