From 4034e314ca40104b2975f6f912fdb08dcfbbe3e0 Mon Sep 17 00:00:00 2001
From: pascalsaul <pascal@saul.nu>
Date: Sun, 27 Aug 2017 08:11:13 +0200
Subject: [PATCH] cross-over serial interface for v2.0

---
 Sonoff-Dual.md | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/Sonoff-Dual.md b/Sonoff-Dual.md
index 3842f201..2ca6c3ad 100644
--- a/Sonoff-Dual.md
+++ b/Sonoff-Dual.md
@@ -7,7 +7,7 @@
 
 Please see the [Hardware Preparation](https://github.com/arendst/Sonoff-Tasmota/wiki/Hardware-Preparation) page for general instructions.
 
-As always, you need to access the serial interface. The **four serial pins** (3V3, Rx, Tx, GND) are available at the short end of the PCB and can be seen on the left side of the first image and are labeled in red on the second image.
+As always, you need to access the serial interface. The **four serial pins** (3V3, Rx, Tx, GND) are available at the short end of the PCB and can be seen on the left side of the first image and are labeled in red on the second image. For the v2.0 version of the board you need to cross-over the serial interface, see [troubleshooting](https://github.com/arendst/Sonoff-Tasmota/wiki/Troubleshooting).
 
 <img alt="Sonoff Dual, GPIO0 grounded" src="https://github.com/arendst/arendst.github.io/blob/master/media/dual2a.jpg" width="48%" />
 <img alt="Alternate GPIO0 spot" src="http://tinkerman.cat/wp-content/uploads/2016/12/20161206_234331s.jpg" width="48%" align="right" />