From 54f9ec5234eaeaa3001e2499450a7d106397d8a2 Mon Sep 17 00:00:00 2001 From: Simon Date: Mon, 11 Nov 2019 22:20:26 +0000 Subject: [PATCH] adjusting some of the English phrasing (hopefully without changing the intended meaning!) --- EXS-2-Channel-Wifi-Dimmer-V4.md | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/EXS-2-Channel-Wifi-Dimmer-V4.md b/EXS-2-Channel-Wifi-Dimmer-V4.md index 57365fb3..44959a91 100644 --- a/EXS-2-Channel-Wifi-Dimmer-V4.md +++ b/EXS-2-Channel-Wifi-Dimmer-V4.md @@ -1,14 +1,14 @@ ## Disclaimer :warning: **DANGER OF ELECTROCUTION** :warning: -:warning: You must chip (ESP8266) disassembled from pcb before flash tasmota!
-:warning: **You can't flash tasmota over firmware from ex-store.de** +:warning: You must de-solder ESP8266 pins from the PCB in order to flash Tasmota!
+:warning: **You can't flash Tasmota over firmware from ex-store.de** -At the moment i see no way to flash minimal.bin over org. firmware. +At the moment I can see no way to flash minimal.bin over the original firmware. :warning: **How flash on assembled PCB** :warning: -Line TX and RX is direct wired with dimm MCU. Cut this 2 lines. For example desolder pin2 and pin3 from MCU.
Solder cable on GPIO0, TX, RX (ESP8266) VCC and GND (See description on pcb). Connect cables with you USB adapter.
Before you flash firmware connect the modul with 230V (Solderpads "230V IN" and "NULL"). Some USB adapters have not enough power. +Line TX and RX is directly wired from the dimmer to the MCU. Cut this 2 lines. For example desolder pin2 and pin3 from MCU.
Solder cable on GPIO0, TX, RX (ESP8266) VCC and GND (See description on pcb). Connect cables with your USB adapter.
Before you flash firmware connect the module with 230V (Solderpads "230V IN" and "NULL") since some USB adapters do not have enough power. ***