From 5efb035383e994d602b7c07543c470295692165f Mon Sep 17 00:00:00 2001 From: lobocobra Date: Tue, 24 Sep 2019 14:12:00 +0200 Subject: [PATCH] Updated Sonoff RF Bridge 433 (markdown) --- Sonoff-RF-Bridge-433.md | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/Sonoff-RF-Bridge-433.md b/Sonoff-RF-Bridge-433.md index a35dbc7e..dd9c8bac 100644 --- a/Sonoff-RF-Bridge-433.md +++ b/Sonoff-RF-Bridge-433.md @@ -43,7 +43,8 @@ See [RF Commands](https://github.com/arendst/Sonoff-Tasmota/wiki/Commands#sonoff 2. Set the module type to `Sonoff Bridge (25)` 3. This step will be different depending on your `Sonoff RF Bridge 433` hardware version. You will have to connect two wires: 1. For `R1`: Connect `GPIO4 to C2Ck` and `GPIO5 to C2D`. - 2. For `R2`: Connect `GPIO4 to C2D` and `GPIO5 to C2Ck`. + 2. For `R2`: Connect `GPIO4 to C2D` and `GPIO5 to C2Ck`. + (!same wiring as on R1 picture for R2. The text on the patine was switched ) 4. Switch the ON/OFF switch on the board to 'OFF' to switch off the RF. 5. Power up the bridge via the 3.3V & GND pins. (See below if you need to power the device through the USB power port) 6. Go to the Web UI **Firmware Upgrade** > **Upgrade by File Upload** (introduced in v6.0.0a)