diff --git a/MCP23008-MCP23017.md b/MCP23008-MCP23017.md
index 78720c0c..5f651f55 100644
--- a/MCP23008-MCP23017.md
+++ b/MCP23008-MCP23017.md
@@ -64,15 +64,15 @@ Where:
 
 Examples of this:
 
-`sensor27 4,1,0` - Will enable D4 for INPUT without internal pull-up resistor
+`sensor29 4,1,0` - Will enable D4 for INPUT without internal pull-up resistor
 
-`sensor27 3,1,1` - Will enable D3 for INPUT with the internal pull-up resistor ENABLED
+`sensor29 3,1,1` - Will enable D3 for INPUT with the internal pull-up resistor ENABLED
 
-`sensor27 5,2,1` - Will enable D5 for INPUT and report on change state from LOW to HIGH and HIGH to LOW via MQTT
+`sensor29 5,2,1` - Will enable D5 for INPUT and report on change state from LOW to HIGH and HIGH to LOW via MQTT
 
-`sensor27 6,3,1` - Will enable D6 for INPUT and report on change state from HIGH to LOW (note pull-up is also enabled)
+`sensor29 6,3,1` - Will enable D6 for INPUT and report on change state from HIGH to LOW (note pull-up is also enabled)
 
-`sensor27 2,4,0` - Will enable D2 for INPUT and report on change state from LOW to HIGH (note pull-up is not enabled)
+`sensor29 2,4,0` - Will enable D2 for INPUT and report on change state from LOW to HIGH (note pull-up is not enabled)
 
 Pull-up resistor support is valid for all modes from 1 through 4