diff --git a/Zigbee.md b/Zigbee.md
index 1f241a95..af406cea 100644
--- a/Zigbee.md
+++ b/Zigbee.md
@@ -114,13 +114,6 @@ The CC2530 requires `Z-Stack_Home_1.2`, of type `Default` (not `Source Routing`)
     [ ] TIMER_SUSPEND
    ```
 
-If you get a message about the flash size not being big enough, this will be because the CC2530 is Debug Locked. This limits the ability of certain commands to report the true flash size. To fix this you need to erase the chip, which can be done as part of flashing the chip. So you will need a 16kb file to flash. The easiest way is to read the existing flash, then re-flash it, using the erase option to erase the chip.
-
-```
-python Python/cc_read_flash.py -p /dev/cu.usbserial-xxx -o x.hex
-python Python/cc_write_flash.py --erase -p /dev/cu.usbserial-xxx -i x.hex
-```
-
 4. Flash the firmware using the following command:  
    _Flashing the CC2530 **takes about 30 minutes**_  
 
@@ -128,6 +121,16 @@ python Python/cc_write_flash.py --erase -p /dev/cu.usbserial-xxx -i x.hex
    python Python/cc_write_flash.py -e -p /dev/cu.usbserial-xxx -i Bin/CC2530_DEFAULT_20190608_CC2530ZNP-Prod.hex
    ```  
    
+   If you get a message about the flash size not being big enough, this will be because the CC2530 is Debug Locked. This
+   limits the ability of certain commands to report the true flash size. To fix this you need to erase the chip, which can
+   be done as part of flashing the chip. So you will need a 16kb file to flash. The easiest way is to read the existing
+   flash, then re-flash it, using the erase option to erase the chip.
+
+   ```
+   python Python/cc_read_flash.py -p /dev/cu.usbserial-xxx -o x.hex
+   python Python/cc_write_flash.py --erase -p /dev/cu.usbserial-xxx -i x.hex
+   ```
+
    ```
    INFO: Found a CC2530 chip on /dev/cu.usbserial-xxxx