diff --git a/Mirabella-Genio-Bulb.md b/Mirabella-Genio-Bulb.md
index 256c82e1..f7051834 100644
--- a/Mirabella-Genio-Bulb.md
+++ b/Mirabella-Genio-Bulb.md
@@ -72,6 +72,7 @@ Connect your FTDI up to these pins:
 Flash with your preferred method [I use this one](https://www.youtube.com/watch?v=UDnNI5wkNNY)
 (remember to connect GPIO0 to GND when plugging in your FTDI this will force the ESP into firmware write mode, you may need to try it a couple of times.
 
+## Module Settings
 Once flashed I use termite (or you could use any serial command tool) to send my settings:
 
 _Note: Change these to match your environment_
@@ -80,12 +81,23 @@ _Note: Change these to match your environment_
 
 Or set manually from the web interface:
 
+### Dimmable warm white or cool white bulbs
 ![Config](https://i.ibb.co/RD4xfMr/Bulb-Config.png)
+I based these settings on the RGBW settings. I would have thought PWM1-3 were redundant, but have only had it work with all of these assigned as per below. The bulb is then tunable, with a brightness slider and a cool/warm slider.
 
+`D3 GPIO0  => None `
+`TX GPIO1  => None`
+`D4 GPIO2  => None`
+`RX GPIO3  => None`
+`D2 GPIO4  => PWM1`
+`D1 GPIO5  => PWM4`
+`D6 GPIO12 => PWM2`
+`D7 GPIO13 => PWM5`
+`D5 GPIO14 => PWM3`
+`D8 GPIO15 => None`
+`D0 GPIO16 => None`
 
-***
-
-Settings for Mirabella RGBW version:
+### RGBW colour bulbs
 
 ![Mirabella RGBW Bulb Tasmota Settings](https://i.ibb.co/BBM0Xyw/mirabella-genio-rgbw-tasmota-settings.png)
 
@@ -96,7 +108,6 @@ Settings for Mirabella RGBW version:
 * D1 GPIO5 = PWM4 = White
 
 
-***
+## Re-assembly
 
-
-(reassemble procedure is the reverse of the disassemble procedure!)
+Re-assembly procedure is the reverse of the disassemble procedure!