From 9b6daa68d3e89b1b157fa5d261afdc3899f0a49d Mon Sep 17 00:00:00 2001
From: afalzon <46345304+afalzon@users.noreply.github.com>
Date: Sun, 13 Jan 2019 08:12:03 +1100
Subject: [PATCH] Updated Mirabella Genio Smart Plug (markdown)

---
 Mirabella-Genio-Smart-Plug.md | 14 ++++++--------
 1 file changed, 6 insertions(+), 8 deletions(-)

diff --git a/Mirabella-Genio-Smart-Plug.md b/Mirabella-Genio-Smart-Plug.md
index bf40007b..4d2ab45c 100644
--- a/Mirabella-Genio-Smart-Plug.md
+++ b/Mirabella-Genio-Smart-Plug.md
@@ -1,4 +1,4 @@
-Mirabella have released a few items under the range "Genio" there were a few posts referring to these being based on the "Tuya" products.
+# Mirabella Genio Smart Plug 
 This is a simple smart plug with the addition of a USB port, as far as I can see the USB port  is 'always on' and is not access this from the ESP module.
 Opening up the device was easy, 2 screws then a small amount of gentle prying exposed the components, 2 more screws had it fully deconstructed.
 
@@ -7,14 +7,12 @@ The ESP module is mounted on a pcb with all of the required pins exposed, a quic
 ![ESP8266 PINOUT](https://i.ibb.co/YRQstXr/ESP-PIN-OUT.png)
 
 I was able to flash by connecting GPIO0 to GND while connecting my Serial Adaptor and plashing as per any other ESP device 
-Use this from the console of the device to configure all your own settings,
+Use this from the console of the device to configure all your own settings:
+
 `Backlog SSID1 YOUR_SSID_NAME; Password1 YOUR_WIFI_PASSWORD; MqttHost MQTT_INTERNAL_IP_ADDRESS; MqttUser MQTT_USER_NAME; MqttPassword MQTT_PASSWORD; GPIO2 56; GPIO12 21; GPIO13 17;topic genio1; FriendlyName Genio1` 
+
 [my prefered flashing method](https://www.youtube.com/watch?v=UDnNI5wkNNY)
-Once flashed, the config should look like: ![config settings](https://i.ibb.co/khNDTvV/settings.png)
-
-
-
-
-
+Once flashed, the config should look like: 
+![config settings](https://i.ibb.co/khNDTvV/settings.png)
 
 hope this helps anyone looking at these products!
\ No newline at end of file