diff --git a/Mirabella-Genio-Smart-Plug.md b/Mirabella-Genio-Smart-Plug.md
index d1d70253..5134fb6f 100644
--- a/Mirabella-Genio-Smart-Plug.md
+++ b/Mirabella-Genio-Smart-Plug.md
@@ -1,14 +1,20 @@
 Mirabella have released a few items under the range "Genio" there were a few posts referring to these being based on the "Tuya" products.
 This is a simple smart plug with the addition of a USB port, as far as I can see the USB port  is 'always on' and is not access this from the ESP module.
-Opening up the device was easy, 2 screws then a small amount of gentle prying exposed the components, 3 more screws had it fully deconstructed.
+Opening up the device was easy, 2 screws then a small amount of gentle prying exposed the components, 2 more screws had it fully deconstructed.
 
 The ESP module is mounted on a pcb with all of the required pins exposed, a quick google image search gave me this information:
 
 ![ESP8266 PINOUT](https://i.ibb.co/YRQstXr/ESP-PIN-OUT.png)
 
-I was able to flash using my [prefered flashing method](https://www.youtube.com/watch?v=UDnNI5wkNNY)
-Once flashed, the config is just like the [Tuya plug](https://github.com/arendst/Sonoff-Tasmota/wiki/Tuya-Smart-Plug-Models-ESP8266MOD-by-AI-THINKER-and-ESP-12F-by-TUYA-LN-0026)
+I was able to flash by connecting GPIO0 to GND while connecting my Serial Adaptor and plashing as per any other ESP device 
+Use this from the console of the device to configure all your own settings,
+`Backlog SSID1 YOUR_SSID_NAME; Password1 YOUR_WIFI_PASSWORD; MqttHost MQTT_INTERNAL_IP_ADDRESS; MqttUser MQTT_USER_NAME; MqttPassword MQTT_PASSWORD; GPIO2 56; GPIO12 21; GPIO13 17;topic genio1; FriendlyName Genio1` 
+[my prefered flashing method](https://www.youtube.com/watch?v=UDnNI5wkNNY)
+Once flashed, the config should look like: [config settings](https://i.ibb.co/khNDTvV/settings.png)
+
+
+
+
 
-![config settings](https://i.ibb.co/khNDTvV/settings.png)
 
 hope this helps anyone looking at these products!
\ No newline at end of file