diff --git a/Sonoff-Pow-and-Pow-R2.md b/Sonoff-Pow-and-Pow-R2.md
index 770cae96..44abea1b 100644
--- a/Sonoff-Pow-and-Pow-R2.md
+++ b/Sonoff-Pow-and-Pow-R2.md
@@ -15,8 +15,8 @@ It can at least destroy your Pow!
 **The GPIOs on the Pow might be connected to AC power**, therefore it is not possible to add sensors to the Pow. 
 
 **The AC connection between Pow and Pow R2 is different**, so be careful when you perform an in-place replacement.
-- Pow R2: Lo-E-E-Li-N-N = LineOut-EarthOut-EarthIn-LineIn-NeutralOut-NeutralIn
-- Pow: Lo-E-E-N-N-Li = LineOut-EarthOut-EarthIn-NeutralOut-NeutralIn-LineIn
+- **Pow R2**: Lo-E-E-Li-N-N = LineOut-EarthOut-EarthIn-LineIn-NeutralOut-NeutralIn
+- **Pow**: Lo-E-E-N-N-Li = LineOut-EarthOut-EarthIn-NeutralOut-NeutralIn-LineIn
 
 ## Serial Connection 
 
@@ -25,8 +25,8 @@ It can at least destroy your Pow!
 Please see the [Hardware Preparation](https://github.com/arendst/Sonoff-Tasmota/wiki/Hardware-Preparation) page for general instructions.
 
 As always, you need to access the serial interface.
-- Pow R2: The **four serial pins** (VDD, E-RX, E-TX, GND) are available at the rear/short end of the PCB. Do not use I04 and I05.
-- Pow: The **four serial pins** (3V3, Rx, Tx, GND) are available at the rear/short end of the PCB as can be seen in the upper part of the image to the right.
+- **Pow R2**: The **four serial pins** (VDD, E-RX, E-TX, GND) are available at the rear/short end of the PCB. Do not use I04 and I05.
+- **Pow**: The **four serial pins** (3V3, Rx, Tx, GND) are available at the rear/short end of the PCB as can be seen in the upper part of the image to the right.
 
 ## Calibration
 Sonoff Pow might need calibration as correct measurements are influenced by hardware and timing differences.