diff --git a/Commands.md b/Commands.md index aad3952c..9099750e 100644 --- a/Commands.md +++ b/Commands.md @@ -18,6 +18,7 @@ - [Displays](#displays) - [Stepper Motors](#stepper-motors) - [Blinds, Shutters and Roller Shades](#blinds-shutters-and-roller-shades) +- [Zigbee](#zigbee) Tasmota provides three powerful man machine interfaces:
**MQTT**, **web** and **serial**. @@ -556,3 +557,13 @@ ShutterSetClose\|Set the shutter closed position. ShutterSetHalfway\| `0..100` *(default = `50`)*
Define shutter half open position (in percent) ShutterStop\|Disengage the relays to stop the shutter See also| [`SetOption80`](#SetOption80) - Enable shutter support + +### [Zigbee](Zigbee) +ยป v7.0.0.3 + +Command|Parameters +-|- +ZigbeePermitJoin|Enables or disables pairing of new devices, see below.

`ZigbeePermitjoin 1` enables pairing for 60 seconds
`ZigbeePermitJoin 99` enables pairing until next boot
`ZigbeePermitJoin 0` disables pairing +ZigbeeReset|Does a factory reset and reconfiguration of the CC2530. Warning: you will need to re-pair all Zigbee devices

Ex: `ZigbeeReset 1` +ZigbeeStatus|Shows data collected from connected Zigbee devices, see examples below.

`ZigbeeStatus` shows the list of all Zigbee devices seen on the network until last boot, with their short address and friendly name.
`ZigbeeStatus 1` adds Manufacturer ID and Model ID of each devices
`ZigbeeStatus 2` adds list of endpoints of each device and the clusterIds supported in each endpoint.
Ex: ```{"ZigbeeStatus":{"Status":1,"Message":"CC2530 booted","RestartReason":"Watchdog","MajorRel":2,"MinorRel":6}}```
  • `Status` contains a numeric code about the status message
    • `0`: initialization complete, **Z2T is running normally**
    • `1`: booting
    • `2`: resetting CC2530 configuration
    • `3`: starting Zigbee coordinator
    • `20`: disabling Permit Join
    • `21`: allowing Permit Join for 60 seconds
    • `22`: allowing Permit Join until next boot
    • `30`: Zigbee device connects or reconnects
    • `31`: Received Node Descriptor information for a Zigbee device
    • `32`: Received the list of active endpoints for a Zigbee device
    • `33`: Received the simple Descriptor with active ZCL clusters for a Zigbee device
    • `50`: reporting CC2530 firmware version
    • `51`: reporting CC2530 device information and associated devices
    • `98`: error, unsupported CC2530 firmware
    • `99`: general error, **Z2T was unable to start**
  • `Message` (optional) a human-readable message
  • other fields depending on the message (e.g., Status=`50` or Status=`51`)
    • +ZigbeeZCLSend|Send a raw ZCL message to a Zigbee device. This is a low-level command, and requires to manually build the ZCL parameters. Most common usage will be provided as high-level functions.