diff --git a/MCP23008-MCP23017.md b/MCP23008-MCP23017.md
index f951137b..5461f254 100644
--- a/MCP23008-MCP23017.md
+++ b/MCP23008-MCP23017.md
@@ -187,13 +187,15 @@ Interrupts will report for individual pins as and when the conditions which were
 
 Interrupt message on HIGH for input pin 0
 ```
-19:28:57 MQT: stat/sonoff/RESULT = {"Time":"2018-07-29T19:28:57","MCP230XX_INT":{"D0":1}}
+MQT: stat/sonoff/RESULT = {"Time":"2018-08-19T16:04:50","MCP230XX_INT":{"D0":1,"MS":301}}
 ```
 Interrupt message on LOW for input pin 1
 ```
-19:28:57 MQT: stat/sonoff/RESULT = {"Time":"2018-07-29T19:28:57","MCP230XX_INT":{"D1":0}}
+MQT: stat/sonoff/RESULT = {"Time":"2018-08-19T16:04:50","MCP230XX_INT":{"D1":0,"MS":519}}
 ```
 
+The state of the pin captured during the interrupt is reported as Dx=y where x is the pin number and y is the state of the pin. In addition the number of milliseconds since the last interrupt occured for the particular pin is also reported as MS=xx where xx is the number of milliseconds recorded.
+
 In addition to the MQTT message the driver will also execute an event command in the following format:
 
 `event MCPINTDxx=y`
@@ -203,9 +205,15 @@ Where xx = the pin number from 0 through 7 (MCP23008) or 0 through 15 (MCP23017)
 The complete output for an interrupt enabled pin would look like this:
 
 ```
-MQT: stat/sonoff/RESULT = {"Time":"2018-08-01T17:53:34","MCP230XX_INT":{"D0":0}}
+MQT: stat/sonoff/RESULT = {"Time":"2018-08-19T16:08:28","MCP230XX_INT":{"D0":0,"MS":217353}}
 SRC: Rule
-RSL: Group 0, Index 1, Command EVENT, Data MCPINTD0=0
+RSL: Group 0, Index 1, Command EVENT, Data MCPINT_D0=0
+MQT: stat/sonoff/RESULT = {"Event":"Done"}
+```
+```
+MQT: stat/sonoff/RESULT = {"Time":"2018-08-19T16:08:46","MCP230XX_INT":{"D0":1,"MS":18101}}
+SRC: Rule
+RSL: Group 0, Index 1, Command EVENT, Data MCPINT_D0=1
 MQT: stat/sonoff/RESULT = {"Event":"Done"}
 ```