From e73f5134ca917626bee425c9808235b1d24465fb Mon Sep 17 00:00:00 2001
From: Michael Ingraham <34340210+meingraham@users.noreply.github.com>
Date: Wed, 24 Jul 2019 09:14:58 -0400
Subject: [PATCH] Choose sonoff-basic for initial flash

---
 Sonoff-DIY.md | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/Sonoff-DIY.md b/Sonoff-DIY.md
index 0e74e229..74800057 100644
--- a/Sonoff-DIY.md
+++ b/Sonoff-DIY.md
@@ -26,11 +26,11 @@ The following procedure upgrades Sonoff eWelink software to Tasmota using a Wind
 - The utility should discover the Sonoff DIY device
 - Select the device and toggle it ON and OFF to verify you are connected to the right device
 - Select Firmware flash
-- Select a [pre-compiled Tasmota binary](http://thehackbox.org/tasmota) or your own self-compiled binary. It must be _smaller than 500k_. _**Do NOT use the sonoff-minimal pre-compiled binary**_ as it does not allow to change any setting.
+- Select a pre-compiled Tasmota binary (e.g., [`sonoff-basic.bin`](http://thehackbox.org/tasmota/020300/sonoff-basic.bin)) or your own self-compiled binary. It must be _smaller than 500k_. _**Do NOT use the sonoff-minimal pre-compiled binary**_ as it does not allow you to change any settings.
 - Select the device in the flash pop-up and then select OK
 - Tasmota will be uploaded and started
 
-Once the firmware upload completes and the device restarts, continue the setup process as if you just installed Tasmota on the device.
+Once the firmware upload completes and the device restarts, it is recommend that you load the firmware variant needed for your device and use case (e.g., `sonoff.bin`). Once the desired firmware is on the device, continue the regular Tasmota setup process.
 
 ### Clean up
 - Quit DIY mode tool