diff --git a/Sonoff-T1-UK,-EU,-and-US.md b/Sonoff-T1-UK,-EU,-and-US.md
index 9c40092d..1c1b37bd 100644
--- a/Sonoff-T1-UK,-EU,-and-US.md
+++ b/Sonoff-T1-UK,-EU,-and-US.md
@@ -20,7 +20,7 @@ See below for verified way of flashing.
 #### Touch Board VER:1
 ![](https://user-images.githubusercontent.com/10469147/34905168-6128981a-f84b-11e7-9cf0-e0e4c3b0bd55.jpg)
 #### Touch Board VER:1.1
-![](https://i.imgur.com/g8FBMPj.png)
+![](https://github.com/arendst/arendst.github.io/blob/master/media/SONOFF-T1-R2-UK-GPIO-PIN-OUTS.png)
 Notes:
 1. There is not enough room with this reversion to fit a header pins on the programming port and still close the case.
 2. That the GPIO0 is connected to the Helper chip on this Ver.  Therefore, the only way to get Ver1.1 of this board into Flash mode is to solder a flylead onto the resistor R19 from pin 15 on the ESP chip (ie GPIO0) and connect this lead to Gnd on power up; the device will set all the touch pads to dim and the WiFi Led D3 will NOT be on at all.