From f208ffd86fe882ccf2882d7a153ba66ff2b82b88 Mon Sep 17 00:00:00 2001 From: cendern Date: Sat, 4 May 2019 21:33:23 -0700 Subject: [PATCH] Added notes --- KMC-70008-light-switch.md | 9 +++++++++ 1 file changed, 9 insertions(+) diff --git a/KMC-70008-light-switch.md b/KMC-70008-light-switch.md index bb18da8b..99c95924 100644 --- a/KMC-70008-light-switch.md +++ b/KMC-70008-light-switch.md @@ -11,3 +11,12 @@ I didn't see any place to add pin headers, but the module has the usual ESP-12 p The button is on GPIO 0, the relay and the white LED are on GPIO 14, the blue LED is on GPIO 13. When the blue LED on GPIO 13 is set to LED1i the white light shines when the relay is off and the blue light illuminates then the relay is on. Additional note: the device kept rebooting back to defaults when I was stumbling through the setup process. Once I set the device to Generic it stopped rebooting on its own. + +Additional notes from another user: +Digiblur's video on how to flash with tuya-convert https://youtu.be/O5GYh470m5k +uses this switch type as the example. I just flashed 4 of these using his instructions (2019-05-04). +I used generic and set these three: +GPIO0:Button1 +GPIO13: Led1i +GPIO14:Relay1 +My blue LED constantly flashes, which differs from the very helpful notes above. I don't know if it explains the difference, but I used Digiblur's Tasmota variant firmware (link in video). \ No newline at end of file