diff --git a/Programming-Debugging-the-pyboard-using-ST-Link-v2.md b/Programming-Debugging-the-pyboard-using-ST-Link-v2.md
index ee5396a..dce6ed6 100644
--- a/Programming-Debugging-the-pyboard-using-ST-Link-v2.md
+++ b/Programming-Debugging-the-pyboard-using-ST-Link-v2.md
@@ -8,6 +8,7 @@ The pyboard does, however, lack an onboard, pre-wired ST-Link/v2 programmer that
 
 - [pyboard v1.1](https://store.micropython.org/product/PYBv1.1)
 - [ST-Link/v2](https://www.st.com/en/development-tools/st-link-v2.html) (the -ISOL version is not needed)
+  - ![st-link/v2](https://www.mouser.com/images/stmicroelectronics/images/board_st-linkv2.jpg)
 - 5 Male to Female Jumper Wires
 
 # Software Setup
@@ -34,7 +35,7 @@ In the following diagram, P1/DFU is labelled BOOT.
 
 ![pvbv11-pinout](https://micropython.org/resources/pybv11-pinout.jpg)
 
-Next, connect the following pins from the ST-Link/v2 to the pyboard. Refer to the [ST-Link/v2 User Manual](https://www.st.com/resource/en/user_manual/dm00026748.pdf).
+Next, connect the following pins from the ST-Link/v2 to the pyboard. Refer to the [ST-Link/v2 User Manual](https://www.st.com/resource/en/user_manual/dm00026748.pdf). Pin 1 on the ST-Link/v2 is the lower left corner of the connecter if you hold the ST-Link/v2 such that the labels are correctly oriented.
 
 ```
 ST-Link/V2        | pyboard v1.1