mirror of https://github.com/arendst/Tasmota.git
36 lines
805 B
Arduino
36 lines
805 B
Arduino
|
// Calibration code for Grove - Multichannel Gas Sensor
|
||
|
|
// Note that it need 10 minutes pre-heat before calibration
|
||
|
|
// This code is writen by Loovee@2016-5-18
|
||
|
|
|
||
|
|
#include <Wire.h>
|
||
|
|
#include "MutichannelGasSensor.h"
|
||
|
|
|
||
|
|
#define SENSOR_ADDR 0X04 // default to 0x04
|
||
|
|
#define PRE_HEAT_TIME 0 // pre-heat time, 10-30 minutes is recommended
|
||
|
|
|
||
|
|
void setup()
|
||
|
|
{
|
||
|
|
Serial.begin(115200);
|
||
|
|
gas.begin(SENSOR_ADDR); //
|
||
|
|
Serial.println("power on, and pre-heat");
|
||
|
|
|
||
|
|
for(int i=60*PRE_HEAT_TIME; i>=0; i--)
|
||
|
|
{
|
||
|
|
Serial.print(i/60);
|
||
|
|
Serial.print(":");
|
||
|
|
Serial.println(i%60);
|
||
|
|
delay(1000);
|
||
|
|
}
|
||
|
|
|
||
|
|
Serial.println("Begin to calibrate...");
|
||
|
|
gas.doCalibrate();
|
||
|
|
Serial.println("Calibration ok");
|
||
|
|
|
||
|
|
gas.display_eeprom();
|
||
|
|
}
|
||
|
|
|
||
|
|
void loop()
|
||
|
|
{
|
||
|
|
|
||
|
|
}
|