Tasmota/lib/esp-knx-ip-0.5.0/README.md

95 lines
2.3 KiB
Markdown
Raw Normal View History

# ESP-KNX-IP #
This is a library for the ESP8266 to enable KNXnet/IP communication. It uses UDP multicast on 224.0.23.12:3671.
It is intended to be used with the Arduino platform for the ESP8266.
## How to use ##
The library is under development. API may change multiple times in the future.
API documentation is available [here](https://github.com/envy/esp-knx-ip/wiki/API)
A simple example:
```c++
#include <esp-knx-ip.h>
const char* ssid = "my-ssid"; // your network SSID (name)
const char* pass = "my-pw"; // your network password
config_id_t my_GA;
config_id_t param_id;
int8_t some_var = 0;
void setup()
{
// Register a callback that is called when a configurable group address is receiving a telegram
knx.register_callback("Set/Get callback", my_callback);
knx.register_callback("Write callback", my_other_callback);
int default_val = 21;
param_id = knx.config_register_int("My Parameter", default_val);
// Register a configurable group address for sending out answers
my_GA = knx.config_register_ga("Answer GA");
knx.load(); // Try to load a config from EEPROM
WiFi.begin(ssid, pass);
while (WiFi.status() != WL_CONNECTED) {
delay(500);
}
knx.start(); // Start everything. Must be called after WiFi connection has been established
}
void loop()
{
knx.loop();
}
void my_callback(message_t const &msg, void *arg)
{
switch (msg.ct)
{
case KNX_CT_WRITE:
// Save received data
some_var = knx.data_to_1byte_int(msg.data);
break;
case KNX_CT_READ:
// Answer with saved data
knx.answer1ByteInt(msg.received_on, some_var);
break;
}
}
void my_other_callback(message_t const &msg, void *arg)
{
switch (msg.ct)
{
case KNX_CT_WRITE:
// Write an answer somewhere else
int value = knx.config_get_int(param_id);
address_t ga = knx.config_get_ga(my_GA);
knx.answer1ByteInt(ga, (int8_t)value);
break;
}
}
```
## How to configure (buildtime) ##
Open the `esp-knx-ip.h` and take a look at the config options at the top inside the block marked `CONFIG`
## How to configure (runtime) ##
Simply visit the IP of your ESP with a webbrowser. You can configure the following:
* KNX physical address
* Which group address should trigger which callback
* Which group address are to be used by the program (e.g. for status replies)
The configuration is dynamically generated from the code.