Tasmota/lib/IRremoteESP8266-2.7.8/examples/TurnOnDaikinAC/TurnOnDaikinAC.ino

68 lines
2.1 KiB
C++

/* Copyright 2017 sillyfrog
*
* An IR LED circuit *MUST* be connected to the ESP8266 on a pin
* as specified by kIrLed below.
*
* TL;DR: The IR LED needs to be driven by a transistor for a good result.
*
* Suggested circuit:
* https://github.com/crankyoldgit/IRremoteESP8266/wiki#ir-sending
*
* Common mistakes & tips:
* * Don't just connect the IR LED directly to the pin, it won't
* have enough current to drive the IR LED effectively.
* * Make sure you have the IR LED polarity correct.
* See: https://learn.sparkfun.com/tutorials/polarity/diode-and-led-polarity
* * Typical digital camera/phones can be used to see if the IR LED is flashed.
* Replace the IR LED with a normal LED if you don't have a digital camera
* when debugging.
* * Avoid using the following pins unless you really know what you are doing:
* * Pin 0/D3: Can interfere with the boot/program mode & support circuits.
* * Pin 1/TX/TXD0: Any serial transmissions from the ESP8266 will interfere.
* * Pin 3/RX/RXD0: Any serial transmissions to the ESP8266 will interfere.
* * ESP-01 modules are tricky. We suggest you use a module with more GPIOs
* for your first time. e.g. ESP-12 etc.
*/
#include <Arduino.h>
#include <IRremoteESP8266.h>
#include <IRsend.h>
#include <ir_Daikin.h>
const uint16_t kIrLed = 4; // ESP8266 GPIO pin to use. Recommended: 4 (D2).
IRDaikinESP ac(kIrLed); // Set the GPIO to be used to sending the message
void setup() {
ac.begin();
Serial.begin(115200);
}
void loop() {
Serial.println("Sending...");
// Set up what we want to send. See ir_Daikin.cpp for all the options.
ac.on();
ac.setFan(1);
ac.setMode(kDaikinCool);
ac.setTemp(25);
ac.setSwingVertical(false);
ac.setSwingHorizontal(false);
// Set the current time to 1:33PM (13:33)
// Time works in minutes past midnight
ac.setCurrentTime(13 * 60 + 33);
// Turn off about 1 hour later at 2:30PM (14:30)
ac.enableOffTimer(14 * 60 + 30);
// Display what we are going to send.
Serial.println(ac.toString());
// Now send the IR signal.
#if SEND_DAIKIN
ac.send();
#endif // SEND_DAIKIN
delay(15000);
}