Updated Sonoff Pow and Pow R2 (markdown)

Theo Arends 2018-04-20 17:12:17 +02:00
parent 688a917746
commit 0ea15590bc
1 changed files with 3 additions and 3 deletions

@ -15,8 +15,8 @@ It can at least destroy your Pow!
**The GPIOs on the Pow might be connected to AC power**, therefore it is not possible to add sensors to the Pow. **The GPIOs on the Pow might be connected to AC power**, therefore it is not possible to add sensors to the Pow.
**The AC connection between Pow and Pow R2 is different**, so be careful when you perform an in-place replacement. **The AC connection between Pow and Pow R2 is different**, so be careful when you perform an in-place replacement.
- Pow R2 AC connection: Lo-E-E-Li-N-N = LineOut-EarthOut-EarthIn-LineIn-NeutralOut-NeutralIn - Pow R2: Lo-E-E-Li-N-N = LineOut-EarthOut-EarthIn-LineIn-NeutralOut-NeutralIn
- Pow AC connecrion: Lo-E-E-N-N-Lin = LineOut-EarthOut-EarthIn-NeutralOut-NeutralIn-LineIn - Pow: Lo-E-E-N-N-Lin = LineOut-EarthOut-EarthIn-NeutralOut-NeutralIn-LineIn
## Serial Connection ## Serial Connection
@ -25,7 +25,7 @@ It can at least destroy your Pow!
Please see the [Hardware Preparation](https://github.com/arendst/Sonoff-Tasmota/wiki/Hardware-Preparation) page for general instructions. Please see the [Hardware Preparation](https://github.com/arendst/Sonoff-Tasmota/wiki/Hardware-Preparation) page for general instructions.
As always, you need to access the serial interface. As always, you need to access the serial interface.
- Pow R2: The **four serial pins** (VDD, E-RX, E-TX, GND) are available at the rear/short end of the PCB as can be seen in the upper part of the image to the right. Do not use I04 and I05. - Pow R2: The **four serial pins** (VDD, E-RX, E-TX, GND) are available at the rear/short end of the PCB. Do not use I04 and I05.
- Pow: The **four serial pins** (3V3, Rx, Tx, GND) are available at the rear/short end of the PCB as can be seen in the upper part of the image to the right. - Pow: The **four serial pins** (3V3, Rx, Tx, GND) are available at the rear/short end of the PCB as can be seen in the upper part of the image to the right.
## Calibration ## Calibration