mirror of https://github.com/arendst/Tasmota.git
Improve image alignment.
parent
8d620e8639
commit
43c61ac3b6
|
@ -93,14 +93,17 @@ Programming the on-board 3.3V [PSA-B](https://www.itead.cc/psa-01.html) is possi
|
||||||
Flashing the ESP8266
|
Flashing the ESP8266
|
||||||
|
|
||||||
Remove the 4 screws on the bottom.
|
Remove the 4 screws on the bottom.
|
||||||
<img alt="SonoffSC" src="https://puu.sh/vZZRI/ff36ff9244.jpg" width="230" align="right"/> The button is connected to GPIO0.
|
The button is connected to GPIO0.
|
||||||
|
|
||||||
You will have to remove the TX jumper in the board to avoid the ATMega328P to interfere in the upload process.
|
You will have to remove the TX jumper in the board to avoid the ATMega328P to interfere in the upload process.
|
||||||
<img alt="SonoffScRemoveTX" src="https://puu.sh/vZZSi/43244f3cc1.jpg" width="230" align="right"/>
|
|
||||||
Press and hold the button while powering the board to set the ESP8266 into flashing mode.
|
Press and hold the button while powering the board to set the ESP8266 into flashing mode.
|
||||||
Note! After flashing you need to set the baudrate to 19200.
|
Note! After flashing you need to set the baudrate to 19200.
|
||||||
Don't forget to reconnect the TX jumper after flashing ;)
|
Don't forget to reconnect the TX jumper after flashing ;)
|
||||||
<img alt="SonoffSCButoom" src="https://puu.sh/vZZSC/aaa140afa3.jpg" width="130" align="right"/>
|
|
||||||
|
<img alt="SonoffSC" src="https://puu.sh/vZZRI/ff36ff9244.jpg" width="230" />
|
||||||
|
<img alt="SonoffScRemoveTX" src="https://puu.sh/vZZSi/43244f3cc1.jpg" width="230" />
|
||||||
|
<img alt="SonoffSCButoom" src="https://puu.sh/vZZSC/aaa140afa3.jpg" width="130" />
|
||||||
|
|
||||||
### 4CH Pro
|
### 4CH Pro
|
||||||
|
|
||||||
|
@ -110,5 +113,4 @@ To program the ESP chip disconnect power from the board, connect a cable from an
|
||||||
|
|
||||||
Use the ESP programming header as described in the picture to upload the firmware and follow regular programming procedure.
|
Use the ESP programming header as described in the picture to upload the firmware and follow regular programming procedure.
|
||||||
|
|
||||||
<img title="Sonoff 4CH Pro programming" src="https://github.com/arendst/arendst.github.io/blob/master/media/4chpro_gpio0.JPG" width="50%" />
|
<img title="Sonoff 4CH Pro programming" src="https://github.com/arendst/arendst.github.io/blob/master/media/4chpro_gpio0.JPG" width="50%"/>
|
||||||
|
|
||||||
|
|
Loading…
Reference in New Issue