Created SonOTA + Espressif2Arduino + Tasmota without compiling (markdown)

SonOTA---Espressif2Arduino---Tasmota-without-compiling.md

@@ -0,0 +1,28 @@
+This is for the lazy people that don't want to open the device, don't want to install SDKs and don't want to compile stuff ;-). You need
+* A standard WiFi
+* A different WiFi (which I created with a smartphone hotspot)
+* A PC or similar with python3 that can run SonOTA
+
+It worked for me with these devices:
+* TH10
+* TH16
+* POW
+* T1 (use the left button to set the device to config mode)
+
+Steps:
+* configure Sonoff using ewlink for local wifi and update the firmware. It does not work with old firmware.
+* create wifi hotspot on smartphone for default indebuurt1/VnsqrtnrsddbrN
+* on PC, extract sonota.py somwhere from the SonOTA project
+* extract http://cputoasters.com/ameyer/sonoff/ssl/sonota-e2a.zip in same dir, should create ssl and static dir (contains just a snakeoil ssl cert and the default compiled e2a binaries directly from the unmodified Espressif2Arduino source)
+* start sonota.py with your standard wifi SSID/PW and PC IP (eg ./sonota.py --wifi-ssid asdfasdf --wifi-password fidjfidfjidjf 192.168.123.123)
+* connect Sonoff, press button for 5s or so until it blinks in blocks of 3, then again 5s or so until it blinks continuously
+* connect to ITEAD-xxxx with PC
+* sonota should send some stuff
+* switch PC to standard Wifi
+* sonota should send more stuff
+* wait for a while, eg 2min, while the device is connecting to the standard wifi and downloading e2a (second part) / Tasmota
+* connect the pc to the hotspot indebuurt1 wifi
+* use `nmap 192.168.43.1-255 -p 80` or similar to find the IP of Tasmota minimal running on the device
+* use a web browser to connect, update to Tasmota standard and configure WiFi / MQTT etc
+
+If there is a problem with hosting the compiled binaries of the unmodified e2a source, just tell me and I will take it down.