mirror of https://github.com/arendst/Tasmota.git
Add serial pin info and AC pin info
parent
b7f9573842
commit
688a917746
|
@ -14,15 +14,19 @@ It can at least destroy your Pow!
|
||||||
|
|
||||||
**The GPIOs on the Pow might be connected to AC power**, therefore it is not possible to add sensors to the Pow.
|
**The GPIOs on the Pow might be connected to AC power**, therefore it is not possible to add sensors to the Pow.
|
||||||
|
|
||||||
**The AC connection between Pow and Pow R2 is different so be careful when you perform an in-place replacement**
|
**The AC connection between Pow and Pow R2 is different**, so be careful when you perform an in-place replacement.
|
||||||
|
- Pow R2 AC connection: Lo-E-E-Li-N-N = LineOut-EarthOut-EarthIn-LineIn-NeutralOut-NeutralIn
|
||||||
|
- Pow AC connecrion: Lo-E-E-N-N-Lin = LineOut-EarthOut-EarthIn-NeutralOut-NeutralIn-LineIn
|
||||||
|
|
||||||
## Serial Connection
|
## Serial Connection
|
||||||
|
|
||||||
<img alt="picture of the Sonoff Pow PCB, the needed pin header can be seen on the top end" src="https://www.itead.cc/wiki/images/e/e3/Sonoff-Pow-00.JPG" width="40%" align="right" />
|
<img alt="picture of the Sonoff Pow PCB, the needed pin header can be seen on the top end" src="https://www.itead.cc/wiki/images/e/e3/Sonoff-Pow-00.JPG" width="50%" align="right" />
|
||||||
|
|
||||||
Please see the [Hardware Preparation](https://github.com/arendst/Sonoff-Tasmota/wiki/Hardware-Preparation) page for general instructions.
|
Please see the [Hardware Preparation](https://github.com/arendst/Sonoff-Tasmota/wiki/Hardware-Preparation) page for general instructions.
|
||||||
|
|
||||||
As always, you need to access the serial interface. The **four serial pins** (3V3, Rx, Tx, GND) are available at the rear/short end of the PCB as can be seen in the upper part of the image to the right.
|
As always, you need to access the serial interface.
|
||||||
|
- Pow R2: The **four serial pins** (VDD, E-RX, E-TX, GND) are available at the rear/short end of the PCB as can be seen in the upper part of the image to the right. Do not use I04 and I05.
|
||||||
|
- Pow: The **four serial pins** (3V3, Rx, Tx, GND) are available at the rear/short end of the PCB as can be seen in the upper part of the image to the right.
|
||||||
|
|
||||||
## Calibration
|
## Calibration
|
||||||
Sonoff Pow might need calibration as correct measurements are influenced by hardware and timing differences.
|
Sonoff Pow might need calibration as correct measurements are influenced by hardware and timing differences.
|
||||||
|
|
Loading…
Reference in New Issue