added info that GPIO0 connection breaks the button ON/OFF function

MGK 2018-10-28 19:29:13 +01:00
parent 0153993fd7
commit 698a504c81
1 changed files with 1 additions and 0 deletions

@ -1,6 +1,7 @@
## Serial connection ## Serial connection
The Sonoff RF needs some tweaking as the connection needed during programming between the button and GPIO0 might not be present. The Sonoff RF needs some tweaking as the connection needed during programming between the button and GPIO0 might not be present.
This connection must be removed after the conversion to Tasmota or a button press will send the device in an ON/OFF loop.
[Phalox](http://phalox.be/wp/electronics/itead-sonoff-slampher-custom-firmware-fix/) explains the case with a picture where you have to install a jumper wire for R21. I received the same result using a small screwdriver and shorting both solder pads of R21 while holding down the button during programming. [Phalox](http://phalox.be/wp/electronics/itead-sonoff-slampher-custom-firmware-fix/) explains the case with a picture where you have to install a jumper wire for R21. I received the same result using a small screwdriver and shorting both solder pads of R21 while holding down the button during programming.