Updated SmartPlug with POW (AISIRER, AVATAR) (markdown)

SmartPlug-with-POW-(AISIRER,-AVATAR).md

@@ -1,34 +1,41 @@
 I got few named Smart Plugs on Amazon with same internal parts.
 
-AISIRER https://www.amazon.de/dp/B07DGH8Y8S
-AVATAR https://www.amazon.de/dp/B07D73S72W
+### AISIRER https://www.amazon.de/dp/B07DGH8Y8S
+### AVATAR https://www.amazon.de/dp/B07D73S72W
 
-Nice of the device:
+### Device:
 - solid design with 16A Relais
+- 8 MB memory chip
 - 2 LEDs
 - POW function (unfortunately did not test yet, need help)
 - very small size, easy to disassemble
 - no need to disassemble PCBs
 - test mode works with 5 or 3.3 V (relais also works)
 
+**Important build flags.**
+* in Platformio for tasmota flag change from 1MB to 8MB is needed, otherwise flash fails.
+
+build_flags = ${esp82xx_defaults.build_flags} -Wl,-Teagle.flash.8m.ld
+* in Arduino IDE:
+
+board selected - "Node MCU 1.0", standard
 Found how some of PINS are linked to main PCB and are easy to connect for flashing
 
-I've decided to use 5V - there is a covered with color pad on the PCB, clean it and attach 5V (see image)
+[PCB board] https://drive.google.com/open?id=1ggvDwS6b83ZdMiPbk4BkTA-crqfShJYv
 
-![PCB board](https://drive.google.com/open?id=1ggvDwS6b83ZdMiPbk4BkTA-crqfShJYv)
-
-Flashing:
-Connect GPIO0 to GND
-Connect RX, TX
-Connect 5V and GND
-Connect USB to PC, start flashing
-
-IMPORTANT: need your help to configure properly POW module, contact me at v.denegin@gmail.com
+### Flashing:
+I've decided to use 5V - there is a painted pad on the PCB, clean it and attach 5V (see image)
+* Connect GPIO0 to GND
+* Connect RX, TX
+* Connect 5V and GND
+* Connect USB to PC, start flashing
 
 Tasmota WEB config (Generic)
-GPIO0 - Led1i
-GPIO2 - Led2i
-GPIO13 - Button1
-GPIO15- Relais1
+* GPIO0 - Led1i
+* GPIO2 - Led2i
+* GPIO13 - Button1
+* GPIO15- Relais1
 
-![webconfig](https://drive.google.com/open?id=12ysKDN6wBvdHVVC33qB3a9rpg5mzKCC7)
+[webconfig] https://drive.google.com/open?id=12ysKDN6wBvdHVVC33qB3a9rpg5mzKCC7
+
+**IMPORTANT:** need your help to configure properly POW module, contact me at v.denegin@gmail.com