Updated Hardware Preparation (markdown)

Thomas Dietrich 2017-06-16 17:50:07 +02:00
parent 7df43ee9a3
commit c8b983cc8e
1 changed files with 5 additions and 5 deletions

@ -42,12 +42,12 @@ The "brain" of the Sonoff module (normally the ESP8266) needs to be put into Fla
To bring a Sonoff module into Flash Mode: To bring a Sonoff module into Flash Mode:
1. Disconnect serial programmer and power) 1. Disconnect serial programmer and power
2. Connect GPIO0 and GND (e.g. Press the button) 2. Connect GPIO0 and GND (e.g., by pressing the on-board button or connection via cable)
3. Connect serial programmer 3. Connect the serial programmer (VCC, RX, TX, GND)
4. Release GPIO0 (after one-two seconds) 4. Disconnect GPIO0 from GND (after one-two seconds)
If everything went well, you are now in Flash Mode and ready to continue with the Sonoff-Tasmota firmware [Upload](https://github.com/arendst/Sonoff-Tasmota/wiki/Upload). If the upload is not able to start, disconnect the module and start the Hardware preaparations from the beginning. If everything went well, you are now in Flash Mode and ready to continue with the Sonoff-Tasmota firmware [Upload](https://github.com/arendst/Sonoff-Tasmota/wiki/Upload). If the upload is not able to start, disconnect the module and start the hardware preparations from the beginning.
---- ----