The hint took me some time to be discovered. Hopefully this saves some time

Norbert Bartels 2019-02-03 02:01:01 +01:00
parent 0730778e6a
commit d8429b3861
1 changed files with 2 additions and 0 deletions

@ -20,6 +20,8 @@ The **four serial pins** (3V3, Rx, Tx, GND) as well as the GPIO0 signal line are
As with all modules pulling GPIO0 to GND is needed to put the chip in programming mode. You need to **connect GPIO0 and GND** during power up. An additional GND pad is available in the middle of the PCB. As with all modules pulling GPIO0 to GND is needed to put the chip in programming mode. You need to **connect GPIO0 and GND** during power up. An additional GND pad is available in the middle of the PCB.
Hint: The **B1 R2** needs the GPIO0 to be connected to the GND pad in the middle of the PCB. Otherwise the flashing is not working.
### LED HEX10 Color Codes ### LED HEX10 Color Codes
The Sonoff B1 uses a TEN charter HEX code for all colors. The Sonoff B1 uses a TEN charter HEX code for all colors.
Colors tested with firmware 5.9.1 20171107: Colors tested with firmware 5.9.1 20171107: