Commit Graph

11 Commits

Author SHA1 Message Date
Mike Causer 47b778332a all: Replace busses with buses.
"buses" is the widely accepted plural form of "bus".
2021-05-20 23:22:03 +10:00
Damien George 5c92ff53fe stm32/boards: Disable onewire module on boards with small flash.
Signed-off-by: Damien George <damien@micropython.org>
2021-02-17 14:42:46 +11:00
Damien George 83461e37d4 stm32/boards: Disable pend_throw, uheapq, utimeq on small-flash boards.
These are mainly used by the previous version of uasyncio which is now
replaced by a newer version, with built-in C module _uasyncio.  Saves about
1300 bytes of flash.
2020-03-28 13:55:59 +11:00
Damien George 799b6d1e0c extmod: Consolidate FAT FS config to MICROPY_VFS_FAT across all ports.
This commit removes the Makefile-level MICROPY_FATFS config and moves the
MICROPY_VFS_FAT config to the Makefile level to replace it.  It also moves
the include of the oofatfs source files in the build from each port to a
central place in extmod/extmod.mk.

For a port to enabled VFS FAT support it should now set MICROPY_VFS_FAT=1
at the level of the Makefile.  This will include the relevant oofatfs files
in the build and set MICROPY_VFS_FAT=1 at the C (preprocessor) level.
2019-11-11 11:37:38 +11:00
Damien George 287800d6e1 stm32: Convert to use FROZEN_MANIFEST to specify frozen code.
All symlinks are removed, frozen files are now referenced via
boards/manifest.py.
2019-10-15 21:36:24 +11:00
Damien George 26e90a0514 stm32/boards: Enable MICROPY_HW_RTC_USE_LSE on L4 boards.
The previous commit changed the default configuration on L4 MCUs to use
LSI, so configure these boards to use LSE again.
2019-10-04 16:10:13 +10:00
Damien George 8485b72d0d stm32/boards/NUCLEO_L432KC: Add config for USB VCP support. 2019-08-15 12:46:34 +10:00
Damien George 009b1f6559 stm32/boards: Rework all stm32??xx_hal_conf.h files to use common code.
This eliminates a lot of duplicated code in these header files.
2019-06-25 14:18:24 +10:00
Damien George 358364b45e stm32/boards/NUCLEO_L432KC: Disable complex nos and default frozen mods.
To save space, since this board only hase 256k of flash.
2019-04-09 11:23:08 +10:00
Damien George 5146e79490 stm32/boards/NUCLEO_L432KC: Specify L4 OpenOCD config file for this MCU. 2018-12-13 13:45:16 +11:00
boochow 69b7b8fa12 stm32/boards: Add NUCLEO_L432KC board configuration files. 2018-12-06 13:33:29 +11:00