It might compile fine with S132 as SoftDevice for nRF52840.
However, there might be different hardware on the SoC which in
turn could make it fail.
SoftDevice S140 is correct BLE stack for nRF52840 SoC and would
provide a more accurate test build.
Eventually it would be good to run the full test suite on a big-endian
system, but for now this will help to catch build errors with the
big-endian configuration.
Signed-off-by: Damien George <damien@micropython.org>
The powerpc port can be built with two different UART drivers, so build
both in CI.
The default compiler is now powerpc64le-linux-gnu- so it does not need to
be specified on the command line.
Specifically:
- pca10040: It was already the default.
- microbit: It uses nRF51, has a Cortex-M0, and has additional libraries.
- pca10056: It has USB CDC.
Explicitly add the repository as upstream and fetch the master commit.
This makes this bare-arm/minimal job more robust when finding the
fork-point of a PR relative to upstream/master (especially for forks of
this repo).
But only when bluetooth is enabled, i.e. if building the dev or coverage
variants, and we have libusb available.
Update travis to match, i.e. specify the variant when doing
`make submodules`.
This is to make the Travis CI size check more robust, by not relying on the
saved firmware from a previous build (which may use a different compiler,
environment, etc) but rather compile both master and the PR and diff them.
This size check now checks both bare-arm and minimal x86-32 builds (before
it just checked minimal Cortex-M build).
Add -Wdouble-promotion and -Wfloat-conversion for most ports to ban out
implicit floating point conversions, and add extra Travis builds using
MICROPY_FLOAT_IMPL_FLOAT to uncover warnings which weren't found
previously. For the unix port -Wsign-comparison is added as well but only
there since only clang supports this but gcc doesn't.
For jobs which run tests multiple times terminate after the first run fails
otherwise the next test run overwrites the previous results, making
--print-failures useless.
Looking at the recent build history the time it takes just to complete the
OSX build is already 12 minutes so make it start early, which brings down
the total build time from about 20 minutes to 14 minutes.
Recent builds are failing with the following error:
Error: pkg-config 0.29.2 is already installed
Assuming this will be the case form now on, we don't have to install
pkgconfig anymore.
This adds a couple of commands to the run-tests script to print the diffs
of failed tests and also to clean up the .exp and .out files after failed
tests. (And a spelling error is fixed while we are touching nearby code.)
Travis is also updated to use these new commands, including using it for
more builds.
The CI job will fail if there is any code which does not conform to the
style encoded by tools/codeformat.py. And it will list any changes
required.
uncrustify is built from source because Ubuntu bionic has uncrustify-0.66.1
which is from 2017/11/22 and is missing many options needed here.
Glenn Ruben Bakke
Damien George
Joel Stanley
Jim Mussared
Damien George
stijn
Thorsten von Eicken
David Lechner
David Lechner
Michael Neuling
Mike Causer