This allows using (almost) the same code for printing floats everywhere,
removes the dependency on sprintf and uses just snprintf and
applies an msvc-specific fix for snprintf in a single place so
nan/inf are now printed correctly.
When entering the interrupt handler of a given GPIO port, more than
one pin could have pending interrupts, therefore care must be taken
to service each interrupt one by one before leaving.
mp_obj_get_int_truncated will raise a TypeError if the argument is not
an integral type. Use mp_obj_int_get_truncated only when you know the
argument is a small or big int.
Hashing is now done using mp_unary_op function with MP_UNARY_OP_HASH as
the operator argument. Hashing for int, str and bytes still go via
fast-path in mp_unary_op since they are the most common objects which
need to be hashed.
This lead to quite a bit of code cleanup, and should be more efficient
if anything. It saves 176 bytes code space on Thumb2, and 360 bytes on
x86.
The only loss is that the error message "unhashable type" is now the
more generic "unsupported type for __hash__".
Unfortunately, MP_OBJ_STOP_ITERATION doesn't have means to pass an associated
value, so we can't optimize StopIteration exception with (non-None) argument
to MP_OBJ_STOP_ITERATION.
When generator raises exception, it is automatically terminated (by setting
its code_state.ip to 0), which interferes with this check.
Triggered in particular by CPython's test_pep380.py.
Exceptions in .close() should be ignored (dumped to sys.stderr, not
propagated), but in uPy, they are propagated. Fix would require
nlr-wrapping .close() call, which is expensive. Bu on the other hand,
.close() is not called often, so maybe that's not too bad (depends,
if it's finally called and that causes stack overflow, there's nothing
good in that). And yet on another hand, .close() can be implemented to
catch exceptions on its side, and that should be the right choice.
The code was apparently broken after 9988618e0e
"py: Implement full func arg passing for native emitter.". This attempts to
propagate those changes to ARM emitter.
The function and corresponding command-line option are only enabled for
the coverage build. They are used to exercise uPy features that can't
be properly tested by Python scripts.
Dave Hylands
stijn
Kaspar Schleiser
Damien George
Daniel Campora
Paul Sokolovsky
Josef Gajdusek
Steve Zatz
blmorris