Created page. Added Features and Status section.

Board-Olimex-STM32-E407.md

@@ -0,0 +1,34 @@
+Cortex M4 STM32F407ZGT6 
+* [Olimex Shop](https://www.olimex.com/Products/ARM/ST/STM32-E407/open-source-hardware)
+* [Manual](https://www.olimex.com/Products/ARM/ST/STM32-E407/resources/STM32-E407.pdf)
+* [OpenOCD configuration](https://www.olimex.com/Products/ARM/ST/STM32-E407/resources/stm32f4x.cfg)
+
+###Features###
+* STM32F407ZGT6 168MHz
+* 1024KB flash ROM, 192KB RAM
+* 3 x 12-bit 2.4 MSPS A/D
+* 2 x 12-bit D/A converters
+* USB OTG FS and USB OTG HS
+* Ethernet 100Mbit
+* 14 timers
+* 3 x SPI
+* 3 x I2C
+* 2 CANs
+* 114 GPIOsC
+* Camera interface
+* JTAG connector with ARM 2x10 pin layout for programming/debugging
+* UEXT connector
+* SD-card
+* Power and user LED
+* Reset and user button
+* 4 full 20-pin Ports with the external memory bus for add-on modules Arduino platform with unsoldered headers
+* Dimensions: 101.6 x 86mm (4 x 3.4")
+
+###Status###
+* Initial support has been implemented  
+ * Working: GPIO, DAC, Timer, CAN, LED, Switch, REPL  
+ * Not tested: SD-Card  
+ * Not working: Ethernet  
+* To build use one of the following methods:
+   1. ```make BOARD=STM32F4DISC```
+   2. ```export BOARD=STM32F4DISC``` in your environment and then just use make.