Blocking on held buttons is bad for MicroPython, since it makes nothing happen on startup-
We need the button to be held but are waiting for a button release after some arbitrary amount of time.
Additionally running code while holding down a button would block normal MicroPython event execution and crash the host's USB bus quite severely.
The Pico Display 2 example specifies a baud of 74 * 1000 * 1000.
However, the highest baud the Raspberry Pi Pico can achieve is
62,500,000.
I checked and even when the baud of 74 * 1000 * 1000 is specified,
it ends up using the max that the Raspberry Pi Pico can handle anyway.
This commit removes the incorrect baud parameter, using the default
parameter instead.
Add the init required for the 320x240 2.0" LCD.
Add an option to set baudrate, 320x240 needs 74MHz for 60FPS
Add library and example for 320x240 2.0 LCD.
Includes "WS2812" and "APA102" modules, wrapping the libraries.
Uses a destructor to clean up the LED strip and resources when MicroPython is stopped/restarted.
Library:
Includes classes for driving WS2812 and APA102 LEDs and defines for Plasma features.
Encoder Example:
Supports connecting a Rotary Encoder via the Qw'St connector.
Works with APA102 or WS281X pixels.
Pressing A will cycle between:
1. Colour change
2. Brightness change
3. Cycle delay
Pressing B will switch back into auto-cycle mode.
Turning the encoder at any time will switch out of auto cycle mode into parameter adjust mode.
Also includes a bugfix to Rotary Encoder for getting the interrupt correctly.
Rainbow Example:
Basic rainbow cycle, press B to speed up and A to slow down.
The switch to common I2C and common definitions for SPI had broken an edge case in Pico Explorer where no backlight pin is used.
The backlight pin was inadvertently set to the front Breakout Garden SPI slot default, which is pin 20- this also happens to be the I2C SDA pin for Pico Explorer, breaking I2C comms.
This fix adds a new special case board "PICO_EXPLORER_ONBOARD" so that ST7789 can be initialised without the backlight pin.
This will be useful for anyone using ST7789 without the rest of the Pico Explorer library, although it feels a little contrived.
Also switches ST7735 over to the common defines.
Removes i2c_inst_t from constructors since it's ignored, and updated the Python bindings not to supply this argument. Instance is inferred from the supplied pins.
Removes all driver-specific SDA/SCL pin definitions and defaults.
Pin type is "uint" everywhere, but "PIN_UNUSED" is *int*_max for MicroPython compat. That's still a lot of pins!
Adds baudrate to the I2C class, and allows a driver (like Trackball) to check the baudrate is supported
This change adds a common I2C class, gathering various I2C functions into a single point of responsibility.
It's necessary for correctly managing the I2C bus pins and state across multiple devices.
* Add a common/pimoroni.hpp to list default pins for various add-ons
* Move the BG SPI Slot enum here for safe keeping
* Switch all GPIO pin references to "uint" to match Pico SDK and bring back PIN_UNUSED as UINT_MAX
Phil Howard
Mike Bell
Jonathan Williamson
Chris Blume
Philip Howard
ZodiusInfuser