Windows 8.1 incorrectly handles search paths on an interface with no
associated resolver, so we have to provide a full primary DNS config
rather than use Windows 8.1's nascent-but-present NRPT functionality.
Fixes#2237.
Signed-off-by: David Anderson <danderson@tailscale.com>
The only connectivity an AWS Lambda container has is an IPv4 link-local
169.254.x.x address using NAT:
12: vtarget_1@if11: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500
qdisc noqueue state UP group default qlen 1000
link/ether 7e:1c:3f:00:00:00 brd ff:ff:ff:ff:ff:ff link-netnsid 1
inet 169.254.79.1/32 scope global vtarget_1
valid_lft forever preferred_lft forever
If there are no other IPv4/v6 addresses available, and we are running
in AWS Lambda, allow IPv4 169.254.x.x addresses to be used.
----
Similarly, a Google Cloud Run container's only connectivity is
a Unique Local Address fddf:3978:feb1:d745::c001/128.
If there are no other addresses available then allow IPv6
Unique Local Addresses to be used.
We actually did this in an earlier release, but now refactor it to
work the same way as the IPv4 link-local support is being done.
Signed-off-by: Denton Gentry <dgentry@tailscale.com>
Split out of Denton's #2164, to make that diff smaller to review.
This change has no behavior changes.
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
It's possible to install a configuration that passes our current checks
for systemd-resolved, without actually pointing to systemd-resolved. In
that case, we end up programming DNS in resolved, but that config never
applies to any name resolution requests on the system.
This is quite a far-out edge case, but there's a simple additional check
we can do: if the header comment names systemd-resolved, there should be
a single nameserver in resolv.conf pointing to 127.0.0.53. If not, the
configuration should be treated as an unmanaged resolv.conf.
Fixes#2136.
Signed-off-by: David Anderson <danderson@tailscale.com>
This raises the maximum DNS response message size from 512 to 4095. This
should be large enough for almost all situations that do not need TCP.
We still do not recognize EDNS, so we will still forward requests that
claim support for a larger response size than 4095 (that will be solved
later). For now, when a response comes back that is too large to fit in
our receive buffer, we now set the truncation flag in the DNS header,
which is an improvement from before but will prompt attempts to use TCP
which isn't supported yet.
On Windows, WSARecvFrom into a buffer that's too small returns an error
in addition to the data. On other OSes, the extra data is silently
discarded. In this case, we prefer the latter so need to catch the error
on Windows.
Partially addresses #1123
Signed-off-by: Adrian Dewhurst <adrian@tailscale.com>
We used to use "redo" for that, but it was pretty vague.
Also, fix the build tags broken in interfaces_default_route_test.go from
a9745a0b68, moving those Linux-specific
tests to interfaces_linux_test.go.
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
netaddr allocated at the time this was written. No longer.
name old time/op new time/op delta
TailscaleServiceAddr-4 5.46ns ± 4% 1.83ns ± 3% -66.52% (p=0.008 n=5+5)
A bunch of the others can probably be simplified too, but this
was the only one with just an IP and not an IPPrefix.
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
Pull in the latest version of wireguard-windows.
Switch to upstream wireguard-go.
This requires reverting all of our import paths.
Unfortunately, this has to happen at the same time.
The wireguard-go change is very low risk,
as that commit matches our fork almost exactly.
(The only changes are import paths, CI files, and a go.mod entry.)
So if there are issues as a result of this commit,
the first place to look is wireguard-windows changes.
Signed-off-by: Josh Bleecher Snyder <josh@tailscale.com>
This leads to a cleaner separation of intent vs. implementation
(Routes is now the only place specifying who handles DNS requests),
and allows for cleaner expression of a configuration that creates
MagicDNS records without serving them to the OS.
Signed-off-by: David Anderson <danderson@tailscale.com>
interfaces.Tailscale only returns an interface if it has at least one Tailscale
IP assigned to it. In the resolved DNS manager, when we're called upon to tear
down DNS config, the interface no longer has IPs.
Instead, look up the interface index on construction and reuse it throughout
the daemon lifecycle.
Fixes#1892.
Signed-off-by: David Anderson <dave@natulte.net>
This reverts commit 7d16c8228b.
I have no idea how I ended up here. The bug I was fixing with this change
fails to reproduce on Ubuntu 18.04 now, and this change definitely does
break 20.04, 20.10, and Debian Buster. So, until we can reliably reproduce
the problem this was meant to fix, reverting.
Part of #1875
Signed-off-by: David Anderson <dave@natulte.net>
Whenever we dropped a packet due to ACLs, wireguard-go was logging:
Failed to write packet to TUN device: packet dropped by filter
Instead, just lie to wireguard-go and pretend everything is okay.
Fixes#1229
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
We had a long-standing bug in which our TUN events channel
was being received from simultaneously in two places.
The first is wireguard-go.
At wgengine/userspace.go:366, we pass e.tundev to wireguard-go,
which starts a goroutine (RoutineTUNEventReader)
that receives from that channel and uses events to adjust the MTU
and bring the device up/down.
At wgengine/userspace.go:374, we launch a goroutine that
receives from e.tundev, logs MTU changes, and triggers
state updates when up/down changes occur.
Events were getting delivered haphazardly between the two of them.
We don't really want wireguard-go to receive the up/down events;
we control the state of the device explicitly by calling device.Up.
And the userspace.go loop MTU logging duplicates logging that
wireguard-go does when it received MTU updates.
So this change splits the single TUN events channel into up/down
and other (aka MTU), and sends them to the parties that ought
to receive them.
I'm actually a bit surprised that this hasn't caused more visible trouble.
If a down event went to wireguard-go but the subsequent up event
went to userspace.go, we could end up with the wireguard-go device disappearing.
I believe that this may also (somewhat accidentally) be a fix for #1790.
Signed-off-by: Josh Bleecher Snyder <josharian@gmail.com>
This tries to generate traffic at a rate that will saturate the
receiver, without overdoing it, even in the event of packet loss. It's
unrealistically more aggressive than TCP (which will back off quickly
in case of packet loss) but less silly than a blind test that just
generates packets as fast as it can (which can cause all the CPU to be
absorbed by the transmitter, giving an incorrect impression of how much
capacity the total system has).
Initial indications are that a syscall about every 10 packets (TCP bulk
delivery) is roughly the same speed as sending every packet through a
channel. A syscall per packet is about 5x-10x slower than that.
The whole tailscale wireguard-go + magicsock + packet filter
combination is about 4x slower again, which is better than I thought
we'd do, but probably has room for improvement.
Note that in "full" tailscale, there is also a tundev read/write for
every packet, effectively doubling the syscall overhead per packet.
Given these numbers, it seems like read/write syscalls are only 25-40%
of the total CPU time used in tailscale proper, so we do have
significant non-syscall optimization work to do too.
Sample output:
$ GOMAXPROCS=2 go test -bench . -benchtime 5s ./cmd/tailbench
goos: linux
goarch: amd64
pkg: tailscale.com/cmd/tailbench
cpu: Intel(R) Core(TM) i7-4785T CPU @ 2.20GHz
BenchmarkTrivialNoAlloc/32-2 56340248 93.85 ns/op 340.98 MB/s 0 %lost 0 B/op 0 allocs/op
BenchmarkTrivialNoAlloc/124-2 57527490 99.27 ns/op 1249.10 MB/s 0 %lost 0 B/op 0 allocs/op
BenchmarkTrivialNoAlloc/1024-2 52537773 111.3 ns/op 9200.39 MB/s 0 %lost 0 B/op 0 allocs/op
BenchmarkTrivial/32-2 41878063 135.6 ns/op 236.04 MB/s 0 %lost 0 B/op 0 allocs/op
BenchmarkTrivial/124-2 41270439 138.4 ns/op 896.02 MB/s 0 %lost 0 B/op 0 allocs/op
BenchmarkTrivial/1024-2 36337252 154.3 ns/op 6635.30 MB/s 0 %lost 0 B/op 0 allocs/op
BenchmarkBlockingChannel/32-2 12171654 494.3 ns/op 64.74 MB/s 0 %lost 1791 B/op 0 allocs/op
BenchmarkBlockingChannel/124-2 12149956 507.8 ns/op 244.17 MB/s 0 %lost 1792 B/op 1 allocs/op
BenchmarkBlockingChannel/1024-2 11034754 528.8 ns/op 1936.42 MB/s 0 %lost 1792 B/op 1 allocs/op
BenchmarkNonlockingChannel/32-2 8960622 2195 ns/op 14.58 MB/s 8.825 %lost 1792 B/op 1 allocs/op
BenchmarkNonlockingChannel/124-2 3014614 2224 ns/op 55.75 MB/s 11.18 %lost 1792 B/op 1 allocs/op
BenchmarkNonlockingChannel/1024-2 3234915 1688 ns/op 606.53 MB/s 3.765 %lost 1792 B/op 1 allocs/op
BenchmarkDoubleChannel/32-2 8457559 764.1 ns/op 41.88 MB/s 5.945 %lost 1792 B/op 1 allocs/op
BenchmarkDoubleChannel/124-2 5497726 1030 ns/op 120.38 MB/s 12.14 %lost 1792 B/op 1 allocs/op
BenchmarkDoubleChannel/1024-2 7985656 1360 ns/op 752.86 MB/s 13.57 %lost 1792 B/op 1 allocs/op
BenchmarkUDP/32-2 1652134 3695 ns/op 8.66 MB/s 0 %lost 176 B/op 3 allocs/op
BenchmarkUDP/124-2 1621024 3765 ns/op 32.94 MB/s 0 %lost 176 B/op 3 allocs/op
BenchmarkUDP/1024-2 1553750 3825 ns/op 267.72 MB/s 0 %lost 176 B/op 3 allocs/op
BenchmarkTCP/32-2 11056336 503.2 ns/op 63.60 MB/s 0 %lost 0 B/op 0 allocs/op
BenchmarkTCP/124-2 11074869 533.7 ns/op 232.32 MB/s 0 %lost 0 B/op 0 allocs/op
BenchmarkTCP/1024-2 8934968 671.4 ns/op 1525.20 MB/s 0 %lost 0 B/op 0 allocs/op
BenchmarkWireGuardTest/32-2 1403702 4547 ns/op 7.04 MB/s 14.37 %lost 467 B/op 3 allocs/op
BenchmarkWireGuardTest/124-2 780645 7927 ns/op 15.64 MB/s 1.537 %lost 420 B/op 3 allocs/op
BenchmarkWireGuardTest/1024-2 512671 11791 ns/op 86.85 MB/s 0.5206 %lost 411 B/op 3 allocs/op
PASS
ok tailscale.com/wgengine/bench 195.724s
Updates #414.
Signed-off-by: Avery Pennarun <apenwarr@tailscale.com>
NetworkManager fixed the bug that forced us to use NetworkManager
if it's programming systemd-resolved, and in the same release also
made NetworkManager ignore DNS settings provided for unmanaged
interfaces... Which breaks what we used to do. So, with versions
1.26.6 and above, we MUST NOT use NetworkManager to indirectly
program systemd-resolved, but thankfully we can talk to resolved
directly and get the right outcome.
Fixes#1788
Signed-off-by: David Anderson <danderson@tailscale.com>
Brad Fitzpatrick
David Anderson
Denton Gentry
David Crawshaw
Adrian Dewhurst
David Anderson
Josh Bleecher Snyder
Josh Bleecher Snyder
Avery Pennarun