mirror of https://github.com/arendst/Tasmota.git
Choose sonoff-basic for initial flash
parent
f565350b05
commit
e73f5134ca
|
@ -26,11 +26,11 @@ The following procedure upgrades Sonoff eWelink software to Tasmota using a Wind
|
||||||
- The utility should discover the Sonoff DIY device
|
- The utility should discover the Sonoff DIY device
|
||||||
- Select the device and toggle it ON and OFF to verify you are connected to the right device
|
- Select the device and toggle it ON and OFF to verify you are connected to the right device
|
||||||
- Select Firmware flash
|
- Select Firmware flash
|
||||||
- Select a [pre-compiled Tasmota binary](http://thehackbox.org/tasmota) or your own self-compiled binary. It must be _smaller than 500k_. _**Do NOT use the sonoff-minimal pre-compiled binary**_ as it does not allow to change any setting.
|
- Select a pre-compiled Tasmota binary (e.g., [`sonoff-basic.bin`](http://thehackbox.org/tasmota/020300/sonoff-basic.bin)) or your own self-compiled binary. It must be _smaller than 500k_. _**Do NOT use the sonoff-minimal pre-compiled binary**_ as it does not allow you to change any settings.
|
||||||
- Select the device in the flash pop-up and then select OK
|
- Select the device in the flash pop-up and then select OK
|
||||||
- Tasmota will be uploaded and started
|
- Tasmota will be uploaded and started
|
||||||
|
|
||||||
Once the firmware upload completes and the device restarts, continue the setup process as if you just installed Tasmota on the device.
|
Once the firmware upload completes and the device restarts, it is recommend that you load the firmware variant needed for your device and use case (e.g., `sonoff.bin`). Once the desired firmware is on the device, continue the regular Tasmota setup process.
|
||||||
|
|
||||||
### Clean up
|
### Clean up
|
||||||
- Quit DIY mode tool
|
- Quit DIY mode tool
|
||||||
|
|
Loading…
Reference in New Issue