Table of Contents

Oittm Smart Plug

Opening the device
PCB layout
Web configuration

If you want the blue LED instead of the red one, use Led2i

Oittm Smart Plug

Oittm provides a relatively cheap Wifi smart plug with an ESP8266, too.

To enable the flash mode of the ESP connect GPIO 0 to GND. The wires have to be soldered directly onto the ESP chip itself, it won't work otherwise.

Opening the device

Remove the small plastics caps on the back and unscrew the first two screws and then again the next ones

PCB layout

!!Make sure to flash with 3.3V and disconnect the power plug from the power outlet before!!

Web configuration

If you want the blue LED instead of the red one, use `Led2i`

Wiki has moved to link on the left.